Black: Recycled PET-G

This was my first spool of PETG ever, and it has set the bar extremely high. It prints so much better than PLA that I have at a similar price. Sometimes I struggle for hours trying to get PLA to print properly, however this PETG will always print correctly on the first try. It has genuinely made me consider switching to PETG as my primary printing material.

Getting a hand written letter from Barbara and some goodies was also a sweet bonus, I showed all my friends.

Works well and fast shipping

I can't get the black petg to stay running. I tried putting a foam filter to brush off any dust, cleaned off the extruder teeth, dried the material for 8 hours, ran up to a high temp of 250C, ran low temp to 225, ran at 10% speed. No matter what I do, the material ends up with a partial blockage at the nozzle. The print then will clear and continue as if nothing happened. But of course the whole print is done-zo. Not exactly helpful when trying to run recycled and make strong printer parts. I do fully understand the risk of printing recycled. Should I be running a larger nozzle? I'm running the standard 0.4mm. I want this to work out.

Let me start by saying that I have had many successful prints with other GreenGate3D filament. However, I received a spool of this filament, and it clogs my nozzle every single time. I can print the same model with the same nozzle and settings on a different spool from GreenGate3D with no issues. I even dried it at the recommended settings, but this did not improve my results. I hope they will replace this spool at no cost (fingers crossed)

I've tried many name brands of PETG. Using this has been my best experience using the material. Gyroid infill goes down smoother & more uniform than any other product I've used to date. I've been using PETG for over 2 yrs. I didnt even need to dehydrate it after unboxing. Thanks ZF & community for recommending!